0.6       engine power coeff
6         drag coef
2.0       low speed drag
3.0       inverse of inertia
5.0       gthrust
0.2       gtrim
0.5       ztrim
10        stalled drop rate
30        stall speed
0.0003    elevator joystick rate
0.0003    rudder joystick rate
0.0004    aileron  joystick rate
0.07       keyboard rate
35.0      best speed
0.8       drag floor
3         gstall
7         zstall
26  2c	plane colors - use egapal.exe to select values
0.5       rudder to roll coupling
0.006     dihedral effect
1         0 is normal, 1 for 3 channel setup with no ailerons

This file needs  values as above with no comments in the start of the file.
If you wish to change the values but save the originals, just paste in your
new values at the top of the file.

Engine power - can vary the total amount of power available.  The number keys
               take a multiple of this value with 1 being engine off and 9
               being max power.
Drag         - varies high speed air drag.  In combination of engine power,
               this value limits top speed of the plane.
Low Drag     - Low speed drag.  This limits the power off glide angle.
Inertia      - how quick the plane responds to power change.  This value
               is inverted from true inertia as higher values give quicker
               response.
Gthrust      - how gravity affects the speed of the plane when climbing or
               diving.
Gtrim        - Simulates wing lift, or up elevator for level flight.  With a
               zero value, the plane would fly same trim upside down.
Ztrim        - how gravity affects the trim of the plane when the wings are
               not level, causing the plane to turn toward the ground.  A zero
               value here would allow level flight in the knife edge position.
Stall drop   - when below the stall speed, the plane drops down.  Causes need
               for a nose up trim to fly level.  Above the stall speed the
               plane is always in trim ( not speed dependant ).
Stall speed  - The speed below which the stall drop becomes a factor.  Can be
               considered ft/sec.  Gstall and Zstall now also factors.
Joystick     - controls rates of joystick
Keyboard rate- response of the plane to the arrow keystokes.
Best speed   - speed at which flight model crosses from low to high speed
               drag model.   Lowest drag at this speed.
Drag floor   - drag at the 'Best speed'
Gstall       - pitch change when stalling.
Zstall       - Yaw change when stalling - high values produce stall turns
roll coupling- Yaw change will cause plane to roll, most planes behave in
               this manner.
dihedral     - Causes plane to have self righting character in roll.
3 channel    - Use 1 here and roll coupling to fly without ailerons.