How to build a Delta wing: 

The main problem of this type of wing, as long as CNC is concerned, is the big chord difference between wing root and tip. As previously shown in the Positionning section, this difference is going to imply a high speed cut at wing root and a low speed at wing tip. Some airfoil warping at tip cannot be avoided. Moreover, the small wingspan is going to require an adequate block positionning on the cutting table.

Section still to be expanded...

L1	Half Wingspan	xxx
C1	Root Chord	xxx
C2	Tip Chord	xxx
F1	Root gap	xxx
H1	Tip dihedral height	xxx

 

• Description:
• References: